|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Folding Knife (& Switchblade) Forum The materials, techniques and the designing of folding knives. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Parts Orginizer
I was staring at my bench today and it was a mess! parts all over the place and 10 different folders mixed together. as I get more productive, I see the need to get things straightened out a bit.
I came up with this sliding shelf that holds 15 individual trays and tucks under my bench. each tray is large enough to hold all the parts for a folder, but small enough to carry around the shop from tool to tool. my bench is still a mess, but its a start at keeping some of the clutter down. I guess time will tell if its a good system or not. Erik Last edited by cnccutter; 10-27-2016 at 11:59 PM. |
#2
|
||||
|
||||
Nice. I began using the plastic organizer trays the fishing guys might use for tackle and accessories:
https://www.amazon.com/Plano-23630-0...+3600+stowaway I have about 10 and use them for other parts storage. Pre-cut backstraps, liners, screws, washers, etc. __________________ Mike |
Tags |
fishing, knives, plastic, screws, shop, small, tool, washers |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
looking for parts | SVanderkolff | The Folding Knife (& Switchblade) Forum | 4 | 11-28-2007 08:37 AM |
Unimat DB and SL Parts | Frank Niro | Tool Time | 0 | 08-24-2007 07:36 PM |
Extra parts?? | goldenbolster | Tool Time | 1 | 04-11-2004 08:13 AM |
All The Parts are Here! | Jeff Higgins | Tool Time | 2 | 10-28-2003 06:37 AM |
F16 Parts | DiamondG Knives | Ed Caffrey's Workshop | 9 | 10-07-2003 05:09 PM |