Nylatron washers - other name?

[plain ol Bill]

I checked MSC for Nylatron material to make my own washers with and could not find it. Is there another name this material goes by? Anyone know if MSC has it? Thanks guys --

[Jeff Higgins]

Nylon 6/6 I think is what they call it.

[oldgrinder]

Originally posted by plain ol Bill
I checked MSC for Nylatron material to make my own washers with and could not find it. Is there another name this material goes by? Anyone know if MSC has it? Thanks guys --

MSC...page 1807 in their master catalog.


Oldgrinder..

[Mail4Tim]

It is also known as MDS-Filled Nylon or MDS Nylon.

Tim

[Don Robinson]

poBill, I bought a small roll of brass shim stock from my local machine shop supply. I used it and like it. Simple to work with, just drill a hole to fit over the pivot bushing, then punch out the O.D. Or just use scissors to cut out the O .D.

MSC should have it in a large range of thicknesses. A roll will last you the rest of your life. Normally 4" wide by 100" in length.

[ConverKing]

I have a sandwich baggie full of those in 1/2 dia. with a .190 thou
hole .015 thou thick if someone would like to have them , I dont make Linerlocks anymore and have no use for them

[Carlton]

Couple of years ago I ordered two sheets of Nylatron .012 X 9.75 X 12. from Sheffield Knifemakers Supply for $1.25 each.
Phone # 386 775 6453.