ddr3 standoffs - The Knife Network Forums : Knife Making Discussions

vic2367 · #1 05-01-2012, 05:49 PM

hi all

am new to knife making and this is my first folder ever

have mostly everything put together , but the standoffs and the flat head screws dont seem to reach the other side of the frame ,, what gives ?

**KNAdmin** · #2 05-04-2012, 10:27 AM

Hi Vic,

Welcome to the forum!!!

Do you have any gap (space) between the liners and the standoff(s) when you look at them over the top?

Alex

vic2367 · #3 05-07-2012, 07:08 PM

no alex , i dont ,, i just ordered some newer longer flathead hex screws,, see if that will work ,,

**KNAdmin** · #4 05-07-2012, 09:24 PM

Did you use pb washers, or the white nylon ones that came with it?

Alex

vic2367 · #5 05-08-2012, 10:19 AM

hmm, i didnt see any washers in this kit ,

**KNAdmin** · #6 05-09-2012, 09:21 AM

My fault, you're right. The liners are coined on that model. I was free-thinking about what could be causing it to be too wide for the liner screws.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Folder clips standoffs	Txcwboy	The Folding Knife Forum	4	02-24-2010 12:47 AM
Make the pivot bushing and standoffs	Don Robinson	KN Class : : Making a framelock folder	6	05-14-2006 06:45 PM
2nd ddr3	tscreener1234	Knife Kits Forum	1	02-15-2006 09:27 PM
1st ddr3	tscreener1234	Knife Kits Forum	6	02-13-2006 08:18 PM
My DDR3-BL,	Ice Tigre	Knife Kits Forum	6	11-29-2005 10:37 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)


	Support KNet