View Single Post
  #3  
Old 10-22-2018, 05:44 PM
TWITHERS TWITHERS is offline
Enthusiast
 
Join Date: Aug 2011
Location: Linden, CA
Posts: 56
Thank you Don. I have a friend who is a retired machinist and his advise is always get the biggest, heaviest tool you can when it come to machine work. Mass is everything. I listen to his advise almost without question but on this his advise was an 8" Yuasa and other makers I've talked to said small and cheap. Quite a difference, so I needed to research some more. Thanks again.
Reply With Quote