View Single Post
  #19  
Old 01-29-2017, 10:59 AM
gkyle840 gkyle840 is offline
Steel Addict
 
Join Date: Oct 2016
Location: Columbus Ohio
Posts: 205
Dave, I started using an 80 grit belt and removed a lot of material from each side. I then went 120, 220, 400 and 600. It was on my new pyroceram platen so hopefully it got everything flat. I did use painters tape on the tang on the oppossite side and put 2 magnets and a flat steel bar to use as a handle to grind the flats. I wonder if when I change sides the tape could have left an invisible residue that darkened?
Reply With Quote