View Single Post
  #16  
Old 06-09-2015, 07:24 AM
Ed Caffrey's Avatar
Ed Caffrey Ed Caffrey is offline
Super Moderator
 
Join Date: Jun 2002
Location: Great Falls, Montana, USA
Posts: 4,393
Send a message via AIM to Ed Caffrey Send a message via Yahoo to Ed Caffrey
I can tell you from experience....you will be totally unhappy trying to mill 1/8" Ti on a Taig. I just got back from the Blade Show....and have been needing to replace my benchtop mill for a while now....and its gona happen. Personally, I'm going to order the G0704 mill from Grizzly. Its not as large as I'd like to go, but is will suffice for the smaller job. (I also own a full size knee mill).... A couple of my friends have purchased this mill, and have had good success with it.


__________________
WWW.CAFFREYKNIVES.NET

Caffreyknives@gmail.com

"Every CHOICE has a CONSEQUENCE, and all your CONSEQUENCES are a result of your CHOICES."
Reply With Quote