View Single Post
  #9  
Old 11-02-2017, 07:36 AM
Crex's Avatar
Crex Crex is offline
Moderator
 
Join Date: Sep 2002
Location: Acworth, GA and/or Hanging Dog, NC
Posts: 3,583
Better practice up on some scrap....welding steel to WI doesn't always go pretty especially in such a small area. Also if you want it to match you will have to re-etch once you clean up the weld.
I prefer, as Ray and Jim stated, either stub or through tang, no guard pins. Well designed and executed slot fit with the handle mechanically attached via pin or threaded nut - just looks better and works for me.


__________________
Carl Rechsteiner, Bladesmith
Georgia Custom Knifemakers Guild, Charter Member
Knifemakers Guild, voting member
Registered Master Artist - GA Council for the Arts
C Rex Custom Knives

Blade Show Table 6-H
Reply With Quote