Busy day today. Rented a big (tracked) bobcat to unload and get the new tools into the shop, pulled out the air hammer and replaced the oak ties underneath it (added 4" to the height), got "Orange Crush", and the rolling mill into the shop, and in place, then got the hydraulic power unit nestled under the overhang on the back of the shop. Now the real work starts.... plumbing in the hydraulics, and then getting everything hooked up and "tweaked" to run well. I'll get pics posted in the morning, but from now my tail is draggin.....so I think about an 8 hour nap is in order.