Parts Orginizer
I was staring at my bench today and it was a mess! parts all over the place and 10 different folders mixed together. as I get more productive, I see the need to get things straightened out a bit.
I came up with this sliding shelf that holds 15 individual trays and tucks under my bench. each tray is large enough to hold all the parts for a folder, but small enough to carry around the shop from tool to tool.
my bench is still a mess, but its a start at keeping some of the clutter down.
I guess time will tell if its a good system or not.
Erik
Last edited by cnccutter; 10-27-2016 at 11:59 PM.
|