View Single Post
  #2  
Old 07-03-2002, 09:23 PM
Mike Sader Mike Sader is offline
Enthusiast
 
Join Date: Jun 2002
Location: Andrews,Texas
Posts: 92
Send a message via Yahoo to Mike Sader
Brian, I'm not Ed but I do use the 1084-15n20 mix for my damascus and heat treat by going to critical (non-magnetic),soak for a few seconds depending on blade thickness, quench(I use veg. oil) @ about 160deg., and temper @ 425 for 1 hr. ,I hope this helps,also Admiral has the tempering info on the 10** steels on their site. Good Luck , Mike
Reply With Quote