|
thanks guys you deffinitly gave me enough to think about...I have never tried using my drill press and a end mill to cut sideways cause I was always told not to but jim you made a point cheaper to replce on of those so before I dump all that money I think I am going to order a few end mills and try and do it that way and if it works and I still want to spend this money on something I could probilly find a hardness tester for that price and I think that would help me fine tune the HT wich I have been doing a lil of anyway but that would tell me what is what consistanly and could only help with quality of the blades...as I said I am going to try a couple end mills in a drill press first and see how that works and take it from there
|