Nice tapered tang, I can do them, but don't for where I live folks just don't want to pay for the extra work. To think you did it with a 1x30 and a 4x36. I can see the 4x36 doing the tang's taper as the 4" width would be an asset. Do you get the "no bump" Tru-Grit belts PoolQs? I do small hollow grinds with my 1x42 so it isn't impossible, just takes longer. You did a very good job.
Ray, I am not gonna make this KITH I'm sorry to say, I've had two orders that
have to be gone Monday (I need that $$!) and am packing after living here for over 9 years. My apartment in NM may not be available till July 1st and I have to go through all the new setup hassles. I don't know if I'll be able. Sorry, it just doesn't look good at the moment.