Thread: epoxy question
View Single Post
  #11  
Old 07-13-2017, 08:26 AM
Ray Rogers's Avatar
Ray Rogers Ray Rogers is offline
Founding Member / Moderator
 
Join Date: Jun 2002
Location: Wauconda, WA
Posts: 9,840
Find another way to shape the handle, that angle grinder is creating far too much heat. If you did find a glue that could take more than 600 degrees then your handle materials would likely start to burn or melt so a higher temp glue is the wrong way to go.

Get a cheap belt sander and use fresh belts and you'll have much less heat. If you can't do that then do it by hand with a good file and some sandpaper ....


__________________

Your question may already have been answered - try the Search button first!






Reply With Quote