View Single Post
  #63  
Old 03-20-2017, 08:28 AM
damon damon is offline
Skilled
 
Join Date: Jul 2013
Location: NE Tennessee
Posts: 409
made some progress last night..... or rather early this morning. just about ready to heat treat.

clamped into the file guide, edge beveled, and a bit of weight taken out of the back end.
(also note the custom hollow grinding jig....)


hollow ground on 10" wheel, ready to engrave signature onto the spine.
red fiber spacer glued onto handle material.
Attached Images
File Type: jpg 0320170440.jpg (77.7 KB, 68 views)
File Type: jpg 0320170910.jpg (64.7 KB, 66 views)
Reply With Quote