View Single Post
  #1  
Old 06-02-2014, 05:46 PM
Jeremy Jeremy is offline
Steel Addict
 
Join Date: Jun 2011
Location: Idaho
Posts: 234
Little Bird and Trout

A few of the others I've been working on took a turn for the worse....due to operator error... So, to make myself feel better, I started this one a little bit ago. I had some bigger pieces of 15n20 laying around and decided to cut a knife out a while back. It was sitting there, so I decided to get to grinding on it. Somehow, I didn't completely mess it up, though I wish I did better on the plunges and a few other things. This knife is pretty thin and has a fair amount of flex to it. With it being so thin and all the extra holes I drilled in the tang, it's super light.













Took it to a nice 600 grit finish, no j-hooks or anything, for once. Picked out a piece of African Blackwood with some figure to it that I think will look nice on it. Still a little ways to go, but might actually hit the finish line with this one.


Jeremy
Reply With Quote