View Single Post
Old 07-13-2022, 03:57 PM
M&J's Avatar
M&J M&J is offline
Join Date: Dec 2004
Location: So. Cal
Posts: 727
I was cleaning up some mammoth ivory scales after leveling the bolsters and it left all sorts of gray behind. I go back with a clean piece of abrasive to make sure the transition is smooth. Then to the buffer. The buffer alone will generally remove most the superficial steel res##ue. That's been my process to verify before buffing that the transition is leveled.

edit When you get the bolsters finished the way you like, taping them off and buffing the handle scales works too.


Last edited by M&J; 07-14-2022 at 06:16 PM.
Reply With Quote