I got a little more work done on the handle this week. I had some Tigerwood left over from another project and cut a pair of book matched scales with the dark grained stripe running down the sides. I decided to go with the superglue finish and have a bit more sanding and buffing to do still yet, but so far I'm pleased with the results. I should have ordered the step drill for the 2-56 button head screws, but instead I used a 5/64" and 9/64" for the shank and countersink holes. After milling on a few sets and finally getting a pair that fit properly, it might actually have been worth it timewise to just pay the $25 for a set from Knifekits
Ek İş arayanlara mükemmel bir site:
www.ekisverenler.com
Ek İş -
İş Bul -
Evde Ek İş