Thread: Bolsters
View Single Post
  #1  
Old 03-27-2018, 09:51 PM
KevBooth KevBooth is offline
Enthusiast
 
Join Date: Apr 2017
Location: Northern Utah
Posts: 79
Bolsters

I’ve been practicing attaching bolsters to scrap of blade steel, and I’m getting pretty good and consistent results. I’m to the point where I feel like I can attach them to a blade and end up with a presentable product.
My question is this. What if anything is everyone using to attach the bolsters to the scale besides the peening of the pins? I’ve seen epoxy used, solder, nothing... I’m just curious what those with experience have used with the best results.
Thank you
Reply With Quote