View Single Post
  #3  
Old 06-15-2018, 04:18 AM
M&J's Avatar
M&J M&J is offline
Master
 
Join Date: Dec 2004
Location: So. Cal
Posts: 890
I sharpen on the 2x72" grinder with a fixture taken from the Lansky type system. Have made variations over the years to adapt and this allows a consistent angle every time. This is one of the early pics. Table is set for a specific degree based on my usual thickness of blades and this works well for my pieces. Will use a well worn 320 or 400 grit. Based on wear I would estimate that the belts are in the 1400-2000+ grit range. If starting a new edge I'll use a fresh 320 then polish the edge with the worn belts followed by a quick pass on the leather with compound.
Attached Images
File Type: jpg sharp3.jpg (38.0 KB, 37 views)


__________________
Mike
Reply With Quote