View Single Post
  #1  
Old 08-17-2018, 10:21 AM
Bend Bend is offline
Registered
 
Join Date: Aug 2018
Posts: 2
Dumb beginner question about beveling

Hello knife makers!

I am an extreme beginner and Iím in the middle of making my first knife. I have a very basic (and Iím sure very stupid) question. When grinding the bevels before heat treat how much of an edge should you bring them to? I ground till the edge was very thin and basically sharpened. Will this edge be damaged or deformed during heat treat? Should I dull or sand it down to make it less fine? Sorry for the stupid question.
Reply With Quote