View Single Post
  #13  
Old 12-21-2017, 01:55 PM
dtec1 dtec1 is offline
Guru
 
Join Date: Aug 2015
Location: ny
Posts: 1,438
yeh its easy to put back togather IF you can get the pieces you will need the screws that hold the handle material back on...then you will need something to use as a pivot screw... then either a back spacer or stand offs. but you will need to know the size of all this stuff....its impossible to tell you what size unless I had it in my hand most likely its a 2-56 screw maybe slightly bigger but the pivot could be 3/16th maybe 14/ or 1/8th most likely the screws for the back spacer or stand off would be 2x56 as well but you would need to make a new back spacer or find some stand offs you can use...if you knew the size of stuff we could tell you where to get the stuff you need. go to a hardware store and try and find the screws that will fit in the threaded hole....then for the pivot find a metal rod in a couple sizes like 1/8th 3/16th or 1/4 just to see what size tightly fits in the hole where the pivot goes if you find out the size you can easily order a pivot
Reply With Quote