Thread: 416 Bolsters
View Single Post
  #3  
Old 06-22-2018, 08:43 PM
TWITHERS TWITHERS is offline
Enthusiast
 
Join Date: Aug 2011
Location: Linden, CA
Posts: 56
Hello Steve,
You say you rough up the tang under the bolsters, what does that achieve? I have gone back and forth on attaching bolsters. First I thought I had to solder them, then I thought epoxy to keep moisture out. I spoke with another maker, and he does neither. He says stainless on stainless requires only a good pin peening. I am assuming if you rough them up, you solder or epoxy? Thanks Steve.
Reply With Quote