View Single Post
  #11  
Old 05-20-2017, 07:24 AM
Crex's Avatar
Crex Crex is offline
Moderator
 
Join Date: Sep 2002
Location: Acworth, GA and/or Hanging Dog, NC
Posts: 3,583
All good stuff here - just a couple of additional tips:
> On the pilot holes try to drill them around 1/2 the size of the final bit size - will cut cleaner with less chance to wander off center if bit flexes a little.
> Always use sharp bits - visual check, feel for "bite", resharpen if necessary (learn to dress/sharpen your bits not all that hard to learn)
> Get a good drill press vise and mount it solid to press table - a good quality cross-feed is worth it's weight in gold.
> Always clamp a blade or other object securely, and check for alignment before starting to drill....you'll keep your fingers longer.


__________________
Carl Rechsteiner, Bladesmith
Georgia Custom Knifemakers Guild, Charter Member
Knifemakers Guild, voting member
Registered Master Artist - GA Council for the Arts
C Rex Custom Knives

Blade Show Table 6-H
Reply With Quote