Quote:
Originally Posted by lpspurgeon
Is there any particular diameter for the set screw on the bolster guide ?
Yea BB I put mine a little wider than .25 I figured if both peices were 1.8" Then it would be a squeeze to get it in there. Hope I didnt mess that part up ... Already
|
Any size screw will work.
The wider slot won't be nearly as accurate. We'll use the edge as a guide for scribing a line on the second liner to position the second bolster, so there will be a large gap that won't make as accurate a a scribed line.
I suggest you make a narrow saw slot on the other end only wide enough to accept two thicknesses of your liner material.