The Knife Network Forums : Knife Making Discussions

The Knife Network Forums : Knife Making Discussions (http://www.knifenetwork.com/forum/index.php)
-   General ::: Items and Bargains (http://www.knifenetwork.com/forum/forumdisplay.php?f=24)
-   -   15N20 for Damascus making (http://www.knifenetwork.com/forum/showthread.php?t=67343)

Raymond 04-24-2017 06:30 PM

15N20 for Damascus making
 
Strips of 15N20 for sale. The pieces are cut 1 1/2 inches wide. They are 0.078 inch thick. Lengths are 6 inch, 7 inch, 8 inch, and 9 inch. The steel is annealed. The "gullet" or "clip" is still on the pieces but the measurements are for full width and length.

I have used this steel for damascus making for many years. I'm out of the Damascus making business now.

Prices are as follows:

6 inch pieces...........50 cents each
7 inch pieces...........75 cents each
8 inch pieces........1.00 each
9 inch pieces........1.25 each

Shipping is extra but not that bad in flat rate boxes.

Contact: raymond@damascusknife.com

You can see this steel in Damascus I have made at: http://www.damascusknife.com


All times are GMT -5. The time now is 02:20 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved