How can I weld to a piece of damascus? [Archive] - The Knife Network Forums : Knife Making Discussions


The Knife Network Forums : Knife Making Discussions > Custom Knife Discussion Boards > Knife Making Discussions > The Damascus Forum > How can I weld to a piece of damascus? PDA View Full Version : How can I weld to a piece of damascus? wineland 09-19-2006, 06:38 AM I was given a nice piece of damascus that is made of 1095 and 15n20 and is only about 5 inches long. I want to weld a piece of 1095 to the end for the handle area but wanted to know if I could just weld it with my mig welder or will this give me problems when it is heat treated? Thanks Richard Wineland Burke 09-19-2006, 08:00 PM weld it then normalize the whole thing and finnish as usual