3 Temper Cycles? [Archive] - The Knife Network Forums : Knife Making Discussions


The Knife Network Forums : Knife Making Discussions > Custom Knife Discussion Boards > Ed Caffrey's Workshop > 3 Temper Cycles? PDA View Full Version : 3 Temper Cycles? Metalpressr 05-15-2001, 07:51 PM I have been going back through the posts and seeing the remnents of the conversations on the triple temper and draw downs in oil. I can't find where the thread started to catch me up to speed on what it all intails. Can somebody kindly tell me on what day the thread started, or under what heading or whatever? Thanks in advance. MIKE KOLLER 05-15-2001, 08:54 PM If you look at the top of the page there is a tutorial section you may find information there and you may also try the search link also.I looked and the information is kinda scattered around a little,but is all good information. Hope this helps. Jason G Howell 05-15-2001, 10:22 PM This is cool. I have been needing to get this info anyway. I just went back through the forum and gathered several good HT topics. Here are the links... topic 104 (http://pub42.ezboard.com/fcustomknifedirectoryforumfrm4.showMessage?topicID =104.topic) topic 70 (http://pub42.ezboard.com/fcustomknifedirectoryforumfrm4.showMessage?topicID =70.topic) topic 29 (http://pub42.ezboard.com/fcustomknifedirectoryforumfrm4.showMessage?topicID =29.topic) topic 73 (http://pub42.ezboard.com/fcustomknifedirectoryforumfrm4.showMessage?topicID =73.topic) first 4 are pretty general and touch on the subject, but these last 2 have some pretty good detail. topic 60 (http://pub42.ezboard.com/fcustomknifedirectoryforumfrm4.showMessage?topicID =60.topic) topic 53 (http://pub42.ezboard.com/fcustomknifedirectoryforumfrm4.showMessage?topicID =53.topic) Thanks Ed and everyone else who contributes, What a resource we have here Ed Caffrey 05-15-2001, 11:08 PM Your welcome Jason! I think everyone owes you a big "THANKS!" for taking the time and effort to sift through posts and find that stuff. It's sometimes tough enough for me to just absorb what's currently up on the posts. I think we should make you the official forum "Archive Master!" :D Metalpressr 05-15-2001, 11:49 PM Thank you very much Jason & Mike. I just came in from the shop. I will take advantage of your kindness and go check out what this is all about. I'm always open to tying something different. Thanks again. Jason G Howell 05-16-2001, 08:30 PM aw, shucks <kicking rock>... weren't nothing guys, just here to help.