Don Cowles
01-08-2001, 06:47 PM
I have to make some room in my shop, so the following items are for sale:
Craftsman 6x48 belt/disk sander (9” disk), all cast iron, with stand - $100
Atlas horizontal mill (model MF), with stand and some tooling - $500
Milwaukee die filer with an assortment of files - $200
Craftsman 1x42 belt/disk sander (6”disk) - $60
Here’s the rub- unless you want to pay for labor to haul it up the stairs and crate it for shipping, you have to come get it (Detroit area). Bring help. If someone wants the whole lot, you can have it for $750.
Don Cowles
Will Whitfoot PM
01-09-2001, 11:15 AM
Sounds like a good deal Don! There was a time I would have snapped it up!
but:
I am retiring from a long career in knife and sword making. The main piece of equipment that needs to move out of here is the heat-treat furnace. I have a custom built electric furnace for swords for sale. It's heavy (500lb), you'd have to pick it up.(Arkansas) I can help load (overhead trusses, w/block and tackle). 40 inches deep inside, 5" inside diam. 65 ampere draw at 220 Volt AC. Automatic set-point controller with anticipating circuit. Argon gas feed line. Sealable enclosure. Reaches 1900 degrees F soak in 45 minutes. $1450
Tom Maringer
maringer@arkansas.net
dogman
01-09-2001, 04:49 PM
Drooolll...maringer....
<img src=http://web.tampabay.rr.com/bbdogg/maringer/Bowie10.jpg >
Hey, Tom. you wouldn't happen to have any Vorpal templates laying around the shop floor, would you:)
viper5192
01-29-2001, 09:47 PM
Don,
still have that mill available? I know someone who might be interested. Could you send me a pic/more info?
Peace
Paul
Don Cowles
01-30-2001, 09:16 AM
Mill is still available- remember, any taker has to come and get it or pay to have it taken out. I'll take a pic tonite.
Don Cowles
02-01-2001, 05:17 PM
Here are the promised pics of the Atlas horizontal mill.
http://www.cowlesknives.com/forumpix/Atlas1.jpg
http://www.cowlesknives.com/forumpix/Atlas2.jpg
http://www.cowlesknives.com/forumpix/Atlas3.jpg
Don Cowles
02-01-2001, 05:21 PM
Once again, I don't know what the problem is, and I don't have time to mess with it now. More later.
CKDadmin
02-01-2001, 08:06 PM
When in doubt, check case and spelling first.
Alex
viper5192
02-01-2001, 08:12 PM
Nice Mill Don. My friend says he wants a vertical mill :(
Thanks anyway
peter nap
02-08-2001, 04:13 AM
Don, I'd love to get the mill but I don't know how to get it here. Do you know the weight?
Don Cowles
02-08-2001, 04:42 PM
Peter- With the stand it is probably between 5-600 Lbs.
peter nap
02-11-2001, 02:22 PM
Thanks anyway Dom...(Groan). I just can't get it here.