A couple of months back I posted some engraving on a little Casull 2000....well here's another one. On this one I did a little close English scroll. On the cylinder I opened up the engraving just a little....not to much....just enough to make it a little different. Most of these little revolvers come with a little longer barrell and a blade front sight. This one was custom made for a special customer of the Casull Mfg. Company. These are great little firearms to engrave....very challenging to lay out the design.
I believe the steel in this gun is 416....any way very nice to engrave. This little Casull is different from the other micro pistols...it's double action and you'll notice it has no hammer. You can't see it in the photo....but I milled out the base just enough to place a pin for a lanyard loop....a little somthing different at the customers request......who knows!

The photos are a little fuzzy....got to get one of those mega pixel cameras........
Thanks for looking................

http://www.imagestation.com/picture/sraid51/p8d08ca738f3cb10d433cbd439ef26f81/fca3a781.jpg

http://www.imagestation.com/picture/sraid51/pc7d30a33011e15b1797d4a718548cb0b/fca3a881.jpg

Super job, Jim!

Great work, as always Jim. When I need to be inspired, I either look at the practice plate you sent me, or look at the work posted on this forum by you guys. I wish everyone would post more photo's, I sure enjoy seeing them. If I get brave enough, I'll be posting a photo of a knife shortly that I'm just finishing.

Elegant looking job, Jim!

I gotta' get me one of them!...:cool:

Tim

Very nice Jim!!!!

Brian

Very, very nice Jim.. I like that tight english scroll. good job ... In a couple of days i will be posting some pictures of a

$10.000
Jack Levin folder that i am engraving , it has a lot of gold wire inlays ...