MEMBER ITEMS FOR SALE
Custom Knives | Other Knives | General Items
-------------------------------------------
New Posts | New PhotosAll Photos




Go Back   The Knife Network Forums : Knife Making Discussions > All Photos > RandyScott's Profile > Albums > Trackrock Hammer-in

|
Picture 20 of 22 from Album Trackrock Hammer-in
Trackrock 2012 Spring 040s

Will Dutton?s fuller tool.. this is so cute and petite I just could not resist taking a few shots of it!  There is an Ace paint paddle for scale; the whole thing will lay in your hand.  The uprights are .25? x 1? x 5.5? ? 6?.  The fullers are 3/8? Grade 8 bolts (yes, it requires a carbide bit to drill the pin holes).  The pin slots were milled.  The portion dropping into the hardy hole was ground till it dropped into the hardy hole.  The two uprights were weld at the bottom.  Very simple. Will has stated he is to weld the top of the uprights to keep them from springing open under the stress of fullering.
Trackrock 2012 Spring 040s

Will Dutton?s fuller tool.. this is so cute and petite I just could not resist taking a few shots of it! There is an Ace paint paddle for scale; the whole thing will lay in your hand. The uprights are .25? x 1? x 5.5? ? 6?. The fullers are 3/8? Grade 8 bolts (yes, it requires a carbide bit to drill the pin holes). The pin slots were milled. The portion dropping into the hardy hole was ground till it dropped into the hardy hole. The two uprights were weld at the bottom. Very simple. Will has stated he is to weld the top of the uprights to keep them from springing open under the stress of fullering.
Picture Added 04-04-2012 02:55 PM
Added by RandyScott



All times are GMT -5. The time now is 07:20 AM.




KNIFENETWORK.COM
Copyright © 2000
? CKK Industries, Inc. ? All Rights Reserved
Powered by ...

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved